run) to determine if the proper dependenciesĪre installed to successfully compile HPLIP.Ģ. Compile-time check mode (-c or -compile): Use this mode before compiling the Note: hp-check can be run in three modes:ġ. This is free software, and you are welcome to distribute it This software comes with ABSOLUTELY NO WARRANTY. 14.0Ĭopyright (c) 2001-8 Hewlett-Packard Development Company, LP 2.8.7)ĭependency/Version Check Utility ver. P Linux Imaging and Printing System (ver. I'm rather a nood when it comes to Linux (but getting smarter everyday :-) ), but any help would be appreciated. The printer is wireless, and again, printing works great. hp-check gives the output at the end of this message. Running XSane ends with message that nothing is found. I've tried both, yet when I am done re-setting up the printer (deleting each time before i set it up again), i am continously prompted to set the printer up.įrom another post i located on here about the c4440, I've installed all packaged listed: When I attempt to refresh the device listing, I am asked to setup a new printer either thru CUPS web interface, or through hp-setup. Now, I am trying to get the scanner portion to work. Using the PPD for the c4400 series, test pages print correctly, and all other print features / quality is outstanding. I enter the IP my router has assigned to the printer, and all is good. From there, I select all option but fax, then continue on. Knowing that, I have been able to get the print portion to work by going through hp-setup, selecting the Network option and clicking the Advanced button. I've read that at the moment, it isn't supported by HPLIP. I have a HP PhotoSmart c4580 AIO printer, and am using Ubuntu 8.04 via KDE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |